Configuring the measurement performance (Config)

Here you can define how measurements are performed.

 

1.   Tap the Config button.

2.   Then you can do the following:

Setting the magnetic declination (Magn. Decl.)

Tap the button to enter the required value.

Defining the stop behavior (Stop Mode)

The stop mode value changes the behavior of the measurement engine, after the Run key is pressed.

      Hold: Measurement continues in the background.

      Stop: Measurement stops and runs again.

You can stop/hold the measurement using the Run key.

To change these parameters:

Tap the button to toggle Hold / Stop.